B2735 Engine Code Repair
Meaning of B2735 engine trouble code is a kind of body trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.
B2735 Fault Symptoms :
- Check engine light comes on
- Engine stalling or misfiring
- Engine performance issues
- Car not starting
If one of these reasons for B2735 code is occuring now you should check B2735 repair processes.
Now don't ask yourself; What should you do with B2735 code ?
The solution is here :
B2735 Possible Solution:
Air Conditioning Pressure Sensor (ACP) Insufficient Pressure Change Each time the A/C clutch engages, the PCM is looking for a pressure change in the refrigerant. If the change in pressure is outside of the calibration the DTC will set. A/C system mechanical failure Open ACP or VREF circuit A/C sensor damaged A/C system electrical failure A/C clutch always engaged Verify A/C system function, including refrigerant charge.
B2735 Code Meaning :
B
OBD-II Diagnostic Body (B) Trouble Code For Engine
2
Fuel And Air Metering (Injector Circuit Malfunctions Only)
7
Fuel Temperature Sensor B Circuit Range/Performance
3
Turbocharger Boost Sensor A Circuit Low
5
Timing Reference High Resolution Signal A Too Many Pulses
Regarding the B2735 code, it would probably be worthwhile to carefully inspect the wire harness near the intake manifold bracket. This is done most easily from below the car in the area near the oil filter.
B2735 OBD-II Diagnostic Body (B) Trouble Code DescriptionB2735 engine trouble code is about Timing Reference High Resolution Signal A Too Many Pulses.Main reason For B2735 CodeThe reason of B2735 OBD-II Engine Trouble Code is Fuel Temperature Sensor B Circuit Range/Performance. |
B2735 DTC specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.